documentation:examples:ipsec_performance_of_a_superserver_5018a-ftn4
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| documentation:examples:ipsec_performance_of_a_superserver_5018a-ftn4 [2020/09/22 11:51] – [DUT] olivier | documentation:examples:ipsec_performance_of_a_superserver_5018a-ftn4 [2020/09/22 11:53] – [IPSec benchmark "Equilibrium throughput" method] olivier | ||
|---|---|---|---|
| Line 57: | Line 57: | ||
| / | / | ||
| < | < | ||
| + | # Loading AES-NI module sooner to be sure it is loaded before IPsec keys | ||
| aesni_load=" | aesni_load=" | ||
| </ | </ | ||
| Line 104: | Line 105: | ||
| ==== Reference Endpoint ==== | ==== Reference Endpoint ==== | ||
| + | |||
| + | / | ||
| + | < | ||
| + | # Loading AES-NI module sooner to be sure it is loaded before IPsec keys | ||
| + | aesni_load=" | ||
| + | </ | ||
| Configure IP address, routes and static IPSec: | Configure IP address, routes and static IPSec: | ||
| < | < | ||
| - | # IPv4 router | ||
| gateway_enable=" | gateway_enable=" | ||
| ifconfig_cxl0=" | ifconfig_cxl0=" | ||
| ifconfig_cxl1=" | ifconfig_cxl1=" | ||
| static_routes=" | static_routes=" | ||
| - | route_generator=" | + | route_generator=" |
| route_receiver=" | route_receiver=" | ||
| static_arp_pairs=" | static_arp_pairs=" | ||
| static_arp_generator=" | static_arp_generator=" | ||
| - | static_arp_receiver=" | + | static_arp_receiver=" |
| # IPv6 router | # IPv6 router | ||
| Line 124: | Line 130: | ||
| ifconfig_cxl1_ipv6=" | ifconfig_cxl1_ipv6=" | ||
| ipv6_static_routes=" | ipv6_static_routes=" | ||
| - | ipv6_route_generator=" | + | ipv6_route_generator=" |
| ipv6_route_receiver=" | ipv6_route_receiver=" | ||
| static_ndp_pairs=" | static_ndp_pairs=" | ||
| static_ndp_generator=" | static_ndp_generator=" | ||
| - | static_ndp_receiver=" | + | static_ndp_receiver=" |
| + | cloned_interfaces=" | ||
| + | create_args_ipsec0=" | ||
| + | ifconfig_ipsec0=" | ||
| + | ifconfig_ipsec0_ipv6=" | ||
| - | # Enabling | + | # Enabling |
| - | kld_list=" | + | |
| ipsec_enable=" | ipsec_enable=" | ||
| </ | </ | ||
| Line 140: | Line 149: | ||
| flush; | flush; | ||
| spdflush; | spdflush; | ||
| - | spdadd 198.18.0.0/ | + | add 198.18.1.208 198.18.1.210 |
| - | spdadd 198.19.0.0/ | + | add 198.18.1.210 198.18.1.208 esp 10001 -m tunnel -u 200 -E aes-gcm-16 " |
| - | add 198.18.1.208 198.18.1.210 esp 0x1000 | + | |
| - | add 198.18.1.210 198.18.1.208 esp 0x1001 | + | |
| - | spdadd 2001:2::/49 2001: | + | |
| - | spdadd 2001: | + | |
| - | add 2001: | + | |
| - | add 2001: | + | |
| </ | </ | ||
| Line 166: | Line 169: | ||
| - Offering load = 5000 Mb/s | - Offering load = 5000 Mb/s | ||
| - Step = 2500 Mb/s | - Step = 2500 Mb/s | ||
| - | - Measured forwarding rate = 1383 Mb/s | + | - Measured forwarding rate = 1598 Mb/s |
| - Forwared rate too low, forcing OLOAD=FWRATE and STEP=FWRATE/ | - Forwared rate too low, forcing OLOAD=FWRATE and STEP=FWRATE/ | ||
| Iteration 2 | Iteration 2 | ||
| - | - Offering load = 1383 Mb/s | + | - Offering load = 1598 Mb/s |
| - | - Step = 691 Mb/s | + | - Step = 799 Mb/s |
| - Trend = decreasing | - Trend = decreasing | ||
| - | - Measured forwarding rate = 1384 Mb/s | + | - Measured forwarding rate = 1597 Mb/s |
| - | - forwarding rate greater than offering load! (forcing FWRATE=OLOAD) | + | |
| Iteration 3 | Iteration 3 | ||
| - | - Offering load = 1728 Mb/s | + | - Offering load = 1997 Mb/s |
| - | - Step = 345 Mb/s | + | - Step = 399 Mb/s |
| - Trend = increasing | - Trend = increasing | ||
| - | - Measured forwarding rate = 1383 Mb/s | + | - Measured forwarding rate = 1602 Mb/s |
| Iteration 4 | Iteration 4 | ||
| - | - Offering load = 1556 Mb/s | + | - Offering load = 1798 Mb/s |
| - | - Step = 172 Mb/s | + | - Step = 199 Mb/s |
| - Trend = decreasing | - Trend = decreasing | ||
| - | - Measured forwarding rate = 1386 Mb/s | + | - Measured forwarding rate = 1599 Mb/s |
| Iteration 5 | Iteration 5 | ||
| - | - Offering load = 1470 Mb/s | + | - Offering load = 1699 Mb/s |
| - | - Step = 86 Mb/s | + | - Step = 99 Mb/s |
| - Trend = decreasing | - Trend = decreasing | ||
| - | - Measured forwarding rate = 1384 Mb/s | + | - Measured forwarding rate = 1600 Mb/s |
| Iteration 6 | Iteration 6 | ||
| - | - Offering load = 1427 Mb/s | + | - Offering load = 1650 Mb/s |
| - | - Step = 43 Mb/s | + | - Step = 49 Mb/s |
| - Trend = decreasing | - Trend = decreasing | ||
| - | - Measured forwarding rate = 1385 Mb/s | + | - Measured forwarding rate = 1603 Mb/s |
| Iteration 7 | Iteration 7 | ||
| - | - Offering load = 1406 Mb/s | + | - Offering load = 1626 Mb/s |
| - | - Step = 21 Mb/s | + | - Step = 24 Mb/s |
| - Trend = decreasing | - Trend = decreasing | ||
| - | - Measured forwarding rate = 1384 Mb/s | + | - Measured forwarding rate = 1604 Mb/s |
| - | Estimated Equilibrium Ethernet throughput= | + | Estimated Equilibrium Ethernet throughput= |
| </ | </ | ||
| - | => We reach about 1.386Gb/s of encrypted traffic (notice the equilibrium script bug at step 2 that could stop here). | + | => We reach about 1.604Gb/s to encrypt 5000 flows. |
| ==== Encryption algorithms ==== | ==== Encryption algorithms ==== | ||
documentation/examples/ipsec_performance_of_a_superserver_5018a-ftn4.txt · Last modified: 2020/09/22 11:56 by olivier